Difference between revisions of "CDM GUI manual"
| Line 20: | Line 20: | ||
Configuration: Contains configuration datapoint values. You can read the current values and input new values to be provided to the Configure commands. | Configuration: Contains configuration datapoint values. You can read the current values and input new values to be provided to the Configure commands. | ||
| − | Exposure time: | + | Pixel clock: It determines the speed at which the sensor cells can be read out. Default value 216, usually you don't need to change this. |
| + | Exposure time: Exposure time for each image. Available range of values 1-999 ms. | ||
| + | FPS: Frames per second. Range of values: 1-10 Hz. | ||
| + | Gain: Range of values: 0-100. | ||
| + | Pixel format: You can select 8bit (IS_CM_MONO8) or 16bit (IS_CM_SENSOR_RAW16). | ||
| + | Comment: If you set any string here it will be added to the header of the saved images. Once set it will be the same for each subsequent image. | ||
| + | |||
| + | Commands: | ||
Revision as of 14:30, 10 March 2021
This page contains instructions for the CDM GUI. In case of issue contact Darko Zaric.
GUI interface
Description of GUI parts: Monitoring: Contains monitoring datapoint values. They are read-only. Hood temperature: Displays temperature inside the hood. Hood humidity: Displays humidity inside the hood. It should be below 80% to operate CDM. Camera temperature status: If the CDM camera is connected it will display it's temperature status. It should be Normal. If it displays Warning or Critical, disconnect the CDM camera and contact Darko. Status: This part displays information about the system status. This part is still unfinished, so it mostly displays No status. FSM state: Display the current Finite State Machine state the CDM is in. FSM transition: Displays if the system is in transition from one FSM state to another. If it is 1 then it is in transition and won't be able to receive FSM commands. If 0, then you can provide the available FSM commands. Circle x: Current circle center in horizontal direction, units in arcsec. OARL 1 x: Current OARL 1 center in horizontal direction, units in arcsec. OARL 2 x: Current OARL 2 center in horizontal direction, units in arcsec.
Configuration: Contains configuration datapoint values. You can read the current values and input new values to be provided to the Configure commands. Pixel clock: It determines the speed at which the sensor cells can be read out. Default value 216, usually you don't need to change this. Exposure time: Exposure time for each image. Available range of values 1-999 ms. FPS: Frames per second. Range of values: 1-10 Hz. Gain: Range of values: 0-100. Pixel format: You can select 8bit (IS_CM_MONO8) or 16bit (IS_CM_SENSOR_RAW16). Comment: If you set any string here it will be added to the header of the saved images. Once set it will be the same for each subsequent image.
Commands:
