Difference between revisions of "Logbook Optics-Setup-Mirca-Apr2018"
(→Enter comments in reverse time order) |
|||
| Line 6: | Line 6: | ||
|- valign="top" | |- valign="top" | ||
| + | |- | ||
| + | | 2018-04-08 || Koji, Satoshi || CMOS camera setup || We put loctite on screws of the lens mount for all the 198 cameras. Then we started attaching CMOS holders and finished ~100. We also made a setup for CMOS angle adjustment. || | ||
|- | |- | ||
| 2018-04-07 || Satoshi || CMOS camera setup || I finished labeling, adjusting lens, IP configuration and IP address table for 198 CMOS cameras. || | | 2018-04-07 || Satoshi || CMOS camera setup || I finished labeling, adjusting lens, IP configuration and IP address table for 198 CMOS cameras. || | ||
Revision as of 21:06, 8 April 2018
Enter comments in reverse time order
| Date | Who did it? | Action | Comments | Documents |
|---|---|---|---|---|
| 2018-04-08 | Koji, Satoshi | CMOS camera setup | We put loctite on screws of the lens mount for all the 198 cameras. Then we started attaching CMOS holders and finished ~100. We also made a setup for CMOS angle adjustment. | |
| 2018-04-07 | Satoshi | CMOS camera setup | I finished labeling, adjusting lens, IP configuration and IP address table for 198 CMOS cameras. | |
| 2018-04-06 | Satoshi | arrival in La Palma |
Trouble Shooting
Tips
- When adjusting lens, we put loctite on pins for focus, but not for pins for iris.
- CMOS camera shields are very tight. We cannot screw some of them completely. In that case you can make use of a CMOS holder to fix them tightly.
- Put loctite on screws of lens mount slowly otherwise loctite can be sticked on the lenses or CMOS sensors.
