Difference between revisions of "GRB221009A calib and r0 to dl1 steps"
| Line 6: | Line 6: | ||
==Cat-A calibration== | ==Cat-A calibration== | ||
| − | + | The coefficients are produced in the official data tree, as lstanalyser. If you want to run it locally, create your own data tree, with a link to the drs4 time, ff systematics and drs4 baseline directories and a local calibration directory (where the calibration files will be automatically stored) and add the option -b "dase_dir_of_your_tree" to the command. Below are listed the commands used for the three days. Due to the not perfect HV FF of the HV setting, some cuts are a bit relaxed by adding specific parameters to the command line. | |
| − | === 2022-10-10: === | + | === 2022-10-10 and 2022-11-05: === |
| − | For | + | For these dates we use run 10359 taken on 2022-11-05, with equal HV setting |
* onsite_create_calibration_file -r 10359 --flatfield-heuristic -y "--FlasherFlatFieldCalculator.charge_median_cut_outliers=[-0.9, 3]" "--LSTCalibrationCalculator.npe_median_cut_outliers=[-6,6]" | * onsite_create_calibration_file -r 10359 --flatfield-heuristic -y "--FlasherFlatFieldCalculator.charge_median_cut_outliers=[-0.9, 3]" "--LSTCalibrationCalculator.npe_median_cut_outliers=[-6,6]" | ||
| + | |||
| + | === 2022-10-12: === | ||
| + | * onsite_create_calibration_file -r 9620 --flatfield-heuristic -y "--FlasherFlatFieldCalculator.charge_median_cut_outliers=[-0.9, 3]" "--LSTCalibrationCalculator.npe_median_cut_outliers=[-6,6]" | ||
Revision as of 10:06, 8 December 2023
This page explains the steps to obtain the required files to calibrate the GRB221009A data and produce the DL1 files under strong moon conditions I concerns the following data and dates:
- 2022-10-10: GRB Moon data
- 2022-10-12: GRB Moon data
- 2022-11-05: Crab Moon data
Cat-A calibration
The coefficients are produced in the official data tree, as lstanalyser. If you want to run it locally, create your own data tree, with a link to the drs4 time, ff systematics and drs4 baseline directories and a local calibration directory (where the calibration files will be automatically stored) and add the option -b "dase_dir_of_your_tree" to the command. Below are listed the commands used for the three days. Due to the not perfect HV FF of the HV setting, some cuts are a bit relaxed by adding specific parameters to the command line.
2022-10-10 and 2022-11-05:
For these dates we use run 10359 taken on 2022-11-05, with equal HV setting
- onsite_create_calibration_file -r 10359 --flatfield-heuristic -y "--FlasherFlatFieldCalculator.charge_median_cut_outliers=[-0.9, 3]" "--LSTCalibrationCalculator.npe_median_cut_outliers=[-6,6]"
2022-10-12:
- onsite_create_calibration_file -r 9620 --flatfield-heuristic -y "--FlasherFlatFieldCalculator.charge_median_cut_outliers=[-0.9, 3]" "--LSTCalibrationCalculator.npe_median_cut_outliers=[-6,6]"
