Lst1 camera hardware change log

LST1 camera hardware change log

Module exchange

	Date	clusco module ID	Module IP	old ID	new ID	issue	elog
	20220511	110	10.1.5.22	1-21	2-48	Suprious trigger rate without HV	elog
	20220511	226	10.1.6.134	1-101	2-135	Fuse Blown	elog
	20210831	47	10.1.5.132	1-135		PLL lock of the 3rd DRS4 in the Dragon	elog
	20210831	123	10.1.5.35	2-136		Impossible to apply HV and too high anode current even with 250 V	elog
	20210302	15	10.1.6.16	2-48		Anode current is too low, no calib pulse	[]
	20210302	110	10.1.5.22	1-148		Pulse was sometimes not in the window. Offset is lower sometimes. The third line of DRS have some problems	[]
	20210302	155	10.1.7.150	1-11		could not power up this module	elog
	20191001	27	10.1.6.28	1-1		hard to power on	[]
	20191001	102	10.1.5.14	2-39		broken PMT	[]
	20191001	244	10.1.6.152	2-39		unusable DRS offset	[]
	20191001	119	10.1.5.31	1-34		unlocked PLL	[]

PMT HV table (EDMS: https://edms.cern.ch/ui/#!master/navigator/document?P:100649165:100710000:subDocs)

	Date	from which run	produced using runXXX	elog
	20200813
	202102XX		3513 (20210215)
	202103XX		3891 (20210303)
	202203XX		7440 (20220323)
	20220524		8410 (20220522)	[1]
	20220527	8485-	8472 (20220526)	[2]

DRS4 pedestal file for online baseline correction

	Date	from which run	pedestal run	elog
	20220527	8480 -	XXX	[3]

White Rabbit Switch reboot:

	Date	MAGIC-LST time offset		elog
	- 20210613	-3.1 us	[4]
	20210613 - 20230228	-6.5 us	[]
	20230310 - 20230330	-76039.3 us	[5]
	20230413 - 202308	-25.1 us	[6]
	20230911 -	-6.2 us	[7]